Log in

No account? Create an account


Previous Entry Share Next Entry
06:58 pm: back in london.

my boiler appears to have broken or something over christmas. it's a combination boiler. fails with error A01 which apparently means "failed to ignite". however, it does produce hot water for a couple of minutes after I reset it before then failing again. so either it has an immersion heater or somesuch as well or it did ignite after all?



Date:January 1st, 2008 07:08 pm (UTC)
Last time I had combi boiler problems (with similar symptoms) it was just the water pressure in the heating circuit being too low. The pressure gauge should read about 1.5 bar.
[User Picture]
Date:January 2nd, 2008 08:53 am (UTC)
Seems to be a bit happier now. Water pressure was 1.5 bar when I got back from pub, is around 2 now (with hot water).
Powered by LiveJournal.com